#E studio 3555 separation roller registration#

Causes: Sensor in the jamming area Refer to the table below.Description: Power-ON jam: The paper is remaining on the paper transport path when power is turned ON.

Exit sensor Sensor check (Perform the input check: 03- OFF//) Actuator check Connector check Harness check LGC board Board check Connector check (CN356, CN355) Harness check Paper stopped in the reverse section Reverse gate solenoid Solenoid check (Perform the output check: 03- 222, 03-223) Connector check (J1010, J1118, CN351) Harness check All Self-diagnosis code Change the setting value of 08-4542 (Switching for incorrect size jam detection) from 1 (Disabled) to 0(Enabled). Scratches on the leading edge of paper Check if toner adheres to the exit gate. Refer to ' Secondary scanning data writing start position'. (Specification Black: 4.2 mm / Color: 5 mm) Use A3/LD paper It is easy to check skew with a copy of a solid image (about 10 mm on its leading edge). Leading edge margin Adjust the margin with 05-4402 (Leading edge position adjustment) to 'Color: 5.5 mm'.

'6.12.1 Adjustment of the Separation Guide Gap' Drawer Check that paper is not skewed in the side guides of the drawer. Paper separation failure at separation guide in the fuser unit Fuser unit Paper transport check Check the gap between the separation guide and fuser belt. Check if the fingers or springs of the separation finger are securely attached.

Remedy: Paper jamming at separation finger in the Fuser Unit.

Causes: Separation finger of the fuser unit Reverse gate solenoid Exit sensor LGC board.

Description: Stop jam at the exit sensor: The trailing edge of the paper does not pass the exit sensor after its leading edge has reached this sensor.

Roller check Developer unit Replace the Developer unit.

Check if paper is folded at the leading edge.

#E studio 3555 separation roller registration#

Remedy: Paper stop jam at Registration roller Drawer Check if any damage is at the leading edge.Description: The paper jam occurred between the registration pass sensor and the paper clinging detection sensor.